FG6100FWC water-cooled flaking mill
Ø600 × 1000 mm alloy rolls and 600–700 kg/h capacity, in a raised version built for single-level plants.
- Ø600 × 1000 mm high Ni-Cr-Mo alloy rolls, centrifugally cast
- Two 22 kW main motors, one per roll
- 600–700 kg/h capacity, 0.25–0.35 mm flakes
Standard model: multi-storey mills
The standard model sits on an upper floor and flakes drop through the slab to the level below, so it needs a multi-storey building.
- Installed on an upper floor
- Flakes fall through a floor opening to the level below
- Needs a multi-storey building, a slab opening and equipment below
Raised: discharge on one floor
The whole mill rises onto 800 mm legs, leaving 620 mm under the outlet, so it fits a single-level plant.
- 800 mm leg platform, 620 mm outlet clearance
- 2645 mm overall, roll centre about 1426 mm
- Motor frame and mill share one base
Pre-assembled in our factory
Base frame, motors, pulleys and guards are fitted and aligned in our factory. On site you connect power, water and product.
- Frame, both main motors, pulleys and guards fitted before shipment
- Belts aligned and tensioned in the factory on screw slide bases
- On site: connect power, water and product
Water-cooled rolls
Cool water enters each roll through a rotary joint and returns to the manifold, so the roll surface stays at a stable temperature and flakes keep their colour.
- Supply and return manifolds come fitted
- Rotary joints carry water inside each roll
- Stable roll temperature: no discolouration or odour
Hard-object protection
If a hard object enters the gap, the floating roll retracts against the hydraulics and disc springs, then closes again by itself.
- Magnets remove tramp iron first
- Other hard objects push the floating roll back
- Accumulator and disc springs absorb the shock; a relief valve opens if pressure climbs
- The roll closes again by itself, protecting rolls and bearings
Side discharge underneath
Flakes drop onto the conveyor under the mill and travel sideways to the dryer-cooler. No floor opening needed.
- Flakes fall from the outlet onto the conveyor
- The conveyor exits through the side panel
- On to drying and cooling, then storage
Installation and connections
Six legs with foot plates and no pit. On site you connect power, cooling water in and out, the product inlet and the discharge conveyor.
- Six legs with foot plates, no pit
- Connections: power, cooling water in/out, product in and out
- Hydraulic unit and control cabinet in one, beside the mill
Contact sales