FG6060FWC water-cooled flaking mill
Ø600 × 600 mm alloy rolls, 360–420 kg/h. The standard version is installed in multi-storey mills and discharges through the floor.
- Capacity360–420 kg/h
- Roll sizeØ600 × 600 mm
- Roll speed388 rpm
- Main motors15 kW × 2
- Total power32.05 kW
- Flake thickness0.25–0.35 mm
- Weight≈ 4.7 t
Feeder
A driven feed roll meters the grain evenly, a hydraulic gate opens and closes the feed, and a VFD sets the rate. Built-in magnets catch tramp iron.
- Feeder gear motor0.55 kW
- Feed rate controlVariable-frequency drive
Rolls
Two water-cooled alloy rolls counter-rotate to press conditioned grain into flakes. Stub shafts make roll changes easy.
- Roll sizeØ600 × 600 mm
- Roll materialHigh Ni-Cr-Mo alloy, centrifugally cast
- Alloy layer20–30 mm
- Roll hardnessHS 68–75
- Roll speed388 rpm
Hydraulic roll closing and gap setting
Hydraulic cylinders close and open the rolls. A sleeve sets the coarse gap and a slide block fine-tunes flake thickness while running.
- Hydraulic pressure3.5–4.0 MPa
- Gap adjustment per step0.1 mm
Cooling water circuit
Supply and return manifolds feed both rolls through rotary joints, connected to mains or recirculated cooling water.
- Water connectionRotary joints + supply/return manifold
Main drive
Two main motors each drive one roll through V-belts with adjustable tension.
- Main motors15 kW × 2
- Total power32.05 kW
- Pulleys4SPC560-5050-115 / 4SPC224-3535-48
Hydraulic unit and control cabinet
Enclosed cabinet with a top control panel. An electric-contact gauge starts and stops the pump automatically, saving energy and holding pressure.
- Hydraulic pressure3.5–4.0 MPa
- Hydraulic systemStacked valves + accumulator, intermittent pump
Belt guards
Fully enclosed perforated stainless guards: ventilated, with the belts visible for inspection.
Contact sales